Sie arbeiten mit Outlook und beim Versenden von E-Mails fügt Outlook automatisch Zeilenvorschübe ein. Diese Problem tritt beim Versenden bzw. Empfangen von Nur-Text-E-Mails in Outlook auf, wenn dies über ein Internet-E-Mailkonto geschieht. In dieser Situation wird der Text immer zwischen einer Länge von 30 und 132 Zeichen umgebrochen.

Um das Problem zu beheben, folgen Sie den nachstehenden Anweisungen.

Important This section, method, or task contains steps that tell you how to modify the registry. However, serious problems might occur if you modify the registry incorrectly. Therefore, make sure that you follow these steps carefully. For added protection, back up the registry before you modify it. Then, you can restore the registry if a problem occurs. For more information about how to back up and restore the registry, click the following article number to view the article in the Microsoft Knowledge Base: 322756 (http://support.microsoft.com/kb/322756/ ) How to back up and restore the registry in Windows

1.Start Registry Editor. To do so, click Start, click Run, type regedt32.exe in the Open box, and then click OK. 2.Locate, and then click the following registry key :

HKEY_Current_User\Software\Microsoft\Office\11.0\Common\MailSettings 3.In the right-pane, double-click the WrapLinesDWORD value. 4.Note the value that appears in the Value Data box. •If the WrapLines value is set to a non-zero value or is not present (the default setting), plain text lines are wrapped before the e-mail message is encoded. In this situation, you must create the WrapLines value. To do so, follow these steps: a.Locate, and then click the following registry key:

HKEY_Current_User\Software\Microsoft\Office\11.0\Common\MailSettings b.On the Edit menu, click Add Value. c.In the Value Name box, type WrapLines. d.Click REG_DWORD in the Data Type drop-down list, and then click OK. e.In the Data box, type 0, and then click OK. •If the WrapLines value is set to 0, no line-wrapping is performed before the e-mail message is encoded. When you create the WrapLines value and set it to 0, you prevent lines from being wrapped with hard line-breaks. If the encoding option information in the “More Information" section of this article uses the default setting of 0, the e-mail message is sent as Quoted-Printable encoding with all lines soft-wrapped correctly. Use the information in the "More Information" section of this article for additional troubleshooting information.

outlook versand zeilenvorschub fügt ein inserts line breaks